Strong power
1500W high-power permanent magnetic brushless motor greatly increases service life up to tripple of the life of traditional type.
The patented pulse technology can keep the tool maintain same speed under heavy load.

Slim&Compact Design
* The slim tool body agrees with the holding habits of the operators, which can significantly reduce the fatigue of grinding for a long time.
* Wholesets of imported original bearings, 3 in 1 dust and water-proof system, longer service life.
* Intelligent IP67 dust proof and waterproof microswitch, easy to start and shut down .
* High overlap coefficient in gear transmission ensure simultaneous clutching of over two sets of gears and their long life.
* Tool free removal of stainless steel dust screen.

Safe & Cost-efficient
* Patented brushless motor design, no need to replace rotor and carbon brush, save maintenance time and accessories cost
* No sparks. Suitable to be designated as tools in special industry.
* Cutting speed is double that of the conventional grinder and grinding speed is 35% faster.
* Saving power energy and materials. Can save 40% of the grinding discs.

Smart Chip
* H and L temperature protection
In case of high and low temperature, it can ensure the normal operation of the machine.
* Powercut protection
In normal operation, the machine will not start up by itself after power failure or plug loosening.
* Soft start
Soft start speed, keep the machine operation under safe conditions.
* Wide voltage fluctuation function
Auto adjustment in case of voltage fluctuation to ensure the constant and optimal working state of the machine.
* Constant speed and steady speed function
No speed decrease under heavy load. The grinding efficiency is increased by 35% and the grinding disc is saved by 40% compared with ordinary angle grinder.
* Real time adjustment of power compensation function
Automatically adjust the required power according to the working condition to ensure the efficient operation of the machine.
* Pulse overload protection function
There is an obvious speed reduction warning during overload transportation, and it stops working after 2 seconds.

Specifications:
Rated Voltage: 220V (support wide voltage 160V~240V)
Frequency: 50Hz / 60Hz
Grinding wheel Dia: 100 mm
Output shaft thread: M10
Rated power: 1500W (1100W optional)
No load speed: 3200~11,000r/min
Dustproof/Waterproof Mesh: Yes
Speed Adjustment: 6-speed adjustment (or fixed speed)
Switch Position: Side / Rear Switch

Whatsapp: +86-15190139703